The Control Panel DF-2200 is ergonomically built for user to operate independently as well as this system can be integrated with other devices also. The user can operate the gun by another master controller, using this control panel as a slave controller. This controller can be further interlocked with external safety devices like doors or dust collectors or Robot etc. which prevent the gun from starting if any fault is active. The system also gives a fault signal if any operational fault / parameters out of range condition occur. Uses precision flowtubes. All our systems here are for JP5000 type gun use, Woka Jet, Jgun, ST4000, Small target and can be adapted to specific guns on request.
These 2 model are full massflow control. All parameters are stored in the plc and can be recall. Master/slave mode, Local/remote, Idle/spray/powder mode, Feeder A, B, A+B, massflow controlled, Water cooling pump with flowmeter and pressure meter, T°water, pressure chamber, Flow Oxygen (or air), Flow Fuel. The right console has a touch screen with recipe management, auto purge of water, diagnostic mode, color monitor. Bigger screens available with video incrustation and camera.
This model is more compact and can be placed on a caddy, wall mounted or on site spray. The console can be moved in the back of a car. This is a full massflow console, reading of carrier gas, closed loop ramp spray parameters for ignition, idle, spray and powder mode, automatic spray, bargraphs, modification during spray, flows of oxygen, fuel, carrier, water, T°, pressure chamber. Remote cooling. Delivered with cooling pump for onsite spraying (or production). On special request, can be installed with a liquid feeder for nanometric powders. Suited of all liquid fuel toch, Designed for JP5000 type, Woka and ST types of torches works also with Starjet Axial powder injection Liquid fuel.[/et_tab][/et_tabs]